WHAT YOU WILL NEED:
- Thin copper coil, found at the hardware store in the copper pipe section
- 3/4" to 1/4" copper reducer found in the same section of your hardware store
- Adhesive putty, or wall tack
DIRECTIONS:
- Gently wind the copper around something circular for the base (like a big roll of tape). Keep bending until you make a little perch on top. Using metal shears, cut the pipe.
- Using pliers, pinch the perch end of the tubing.
- Squish a small pinch of the putty into the ¼” end of the reducer fitting and slide it onto the perch end of the tubing.